Difference between revisions of "Retrieving a Dell TSR Log"

From Internet Computer Wiki
Jump to: navigation, search
(Replaced content with "Please see new page: https://wiki.internetcomputer.org/wiki/IDRAC_access_and_TSR_logs")
Tag: Replaced
 
Line 1: Line 1:
When Dell is called to service a server, they will ask for the service tag. This is the serial number for the server which is listed on the pull-out tag of the server.
+
Please see new page:
 
+
https://wiki.internetcomputer.org/wiki/IDRAC_access_and_TSR_logs
They will also frequently ask for a TSR log. Here are several sets of directions that may be needed, depending on the situation:
 
 
 
* [https://www.dell.com/support/kbdoc/en-us/000130077/poweredge-how-to-use-the-idrac-direct-feature?lwp=rt How to Use the iDRAC Direct Feature]
 
* [https://www.dell.com/support/kbdoc/en-us/000126308/export-a-supportassist-collection-via-idrac9 Export a SupportAssist collection via iDRAC9]
 
* [https://www.dell.com/support/kbdoc/en-us/000177787/how-to-change-the-default-login-password-of-the-idrac-9 Changing the Integrated Dell Remote Access Controller 9 (iDRAC9) default login password]
 
** [https://www.dell.com/community/PowerEdge-Hardware-General/Reset-Dell-R630-iDRAC-Password/m-p/5007028 This information] from Dell may also be helpful if you need to reset it with KVM connected.
 
* If the faulty server is not allowing access to the iDRAC, then the Lifecycle Controller can be used to pull a TSR log and export it to a USB using [https://www.dell.com/support/kbdoc/en-us/000130772/export-support-assist-collection-and-raid-controller-log-through-poweredge-lifecycle-controller these directions] from Dell.
 
** Note that if this is the first time the lifecycle controller has been launched, you will be greeted with a 5-step setup wizard. One of the steps includes network configuration. For this, everything must be left blank, but they are forced to choose a NIC interface in a dropdown menu. In that dropdown menu, please have them select a NIC interface that is unused.
 
* Use Dell's directions to access the network settings of the iDRAC through the BIOS using a crash cart:
 
** https://www.dell.com/support/kbdoc/en-us/000177212/dell-poweredge-how-to-configure-the-idrac9-and-the-lifecycle-controller-network-ip
 
** The settings you would be looking to change are the IPv4 settings.
 
** After you have set the IP of the iDRAC, you can connect your laptop directly to the iDRAC port.
 
** Once connected you can go into your laptop network settings and change your IP to something that is within the same network space of the iDRAC.
 
** Once complete, you should be able to open a browser and go to the IP that you set the iDRAC.
 

Latest revision as of 17:35, 4 April 2023